GENIUS-II POWER SUPPLYOwner's ManualPlease read the Installation section of this manual before installing the product.
to the caravan battery connections on the Genius-II. Use whichever connection point is most convenient from a wiring perspective.Note: A solar panel v
11Figure 3: DC Wiring DiagramCaravanBattery–+12VFUSE+Load 1–Optional SwitchClose to disconnect all LoadsFuse for Caravan Battery/Solar Regulator+Load
Battery Connection/Disconnection Procedure WARNING: Sparks have the potential to cause an explosion should combustible gases be present. The following
This product is suitable for charging 12 V Sealed Lead-Acid (SLA) batteries including Valve-Regulated Lead-Acid (VRLA) batteries, both Absorbed Glass
Functional DescriptionFunctional DiagramAC/DC Power SupplyThis provides an isolated 13.65 Vdc output for powering of the load and charging of the batt
following: The power supply is a three stage battery charger with Boost, Float, and Store charging modes to ensure long battery life. Charging current
Charging AlgorithmFloat Mode Store Mode Periodic Boost ModeDuring Float mode the battery is charged at 15 A until the float voltage is reached. Then i
LED IndicatorA multi-colour LED indicator is provided to indicate the following operating conditions:Colour ConditionGreen (Solid) Mains present AND b
SpecificationsInput Voltage: 240 Vac nominal, ±10%, 50/60 HzThe power supply will withstand a 5 minute, +15 % surge on the maximum nominal voltageInpu
Warranty Terms and ConditionsThe benefits provided to you under this warranty are in addition to any other rights or remedies you may have, as a consu
Copyright © Diverse Power Systems 2013DisclaimerDiverse Power Systems makes no claim as to the accuracy or suitability of the information contained in
DESIGNED AND MANUFACTURED IN AUSTRALIA023484 Rev A
ContentsIntroduction... 4Safety Precautions..
IntroductionSafety PrecautionsPlease read the Safety Precautions carefully before installing the power supply. Be sure to observe all precautions with
AccessoriesAccessories provided with this product are:1. Owner's ManualAbout the Genius-II Power SupplyThe Genius-II has been designed for use in
Names and Functions of Parts Mains Cable (permanently connected)240 V input power for charging the caravan battery and powering loads Mounting Bracket
Installing The Genius-II Power SupplyPersonnelInstallation is to be carried out only by suitably qualified personnel.Ventilation, Orientation, and The
Load, Battery and External DC Input ConnectionsAll DC connections should be wired according to Figure 3 on page 11.A block diagram of the basic intern
Load ConnectionsUp to 10 independently-fused loads may be connected. Loads are attached using the two 10-way terminal blocks.Refer to Table 1 for wire
Comments to this Manuals